How to Assemble a Bugaboo
You've seen and heard how well it works, going from a four-wheel stroller for normal use to a two-wheel stroller for use on a beach. Back as a four-wheel stroller, you love that the seat adjusts so that your baby either faces the world or faces you. But now that you have a Bugaboo stroller, you need to know how to assemble it.
Things You'll Need
- Bugaboo stroller
Instructions
Assembly
Hold the handlebar in a perpendicular position to you and the floor, so that one side of the stroller is facing upward and only one of the movable joints is contacting the floor for stabilization, while the chassis is still in the folded position. Snap a large wheel into place into the only side-facing hole on that side, which you now have facing upward. Reverse sides and snap a large wheel into the other side-facing hole. Snap a small wheel into one of the the openings facing you, while both movable joints are stabilized on the floor, and watching to see that the knob on the frame of the wheel protrudes through the wheel opening on the chassis. Snap the second small wheel into the other opening facing you, again watching to see that the knob on the frame of the wheel protrudes through the wheel opening on the chassis. Lay the chassis on fully on the ground so that the handlebar is topmost and closest to you. Depress the lock and release button on the handlebar with your left hand, and raise the handlebar. Push the handlebar away from you until it locks open. Pull the chassis slightly back to you by the handlebar, and with one foot step on the lowermost crossbar -- which holds the small wheels -- while continuing to pull the handlebar toward you. The crossbar with the wheels will spring forward from underneath your foot as you continue pulling the handlebar toward you, and the Bugaboo will open to its upright, normal operating position. Put the seat cover over the seat, pulling it snug onto and fitting it around the seat, and pulling the seat belts through the seat belt opening in the seat cover. Lower the seat stand until the seat stand fully opens. Lower the seat stand onto the middle crossbar and push down and snap the seat into place. Snap the seat-carrying handle into place. Press the lock and release buttons on both sides of the seat to adjust the angle of the seat. Pull the lock lever down flush with the handlebar to complete assembly.